Linksys router validating identity
This can be entered as 5 or 13 as I characters or 10 or 26 hexadecimal characters. I tried this and when attempting to connect again, a prompt box appeared asking for a network key (also called a WEP or WPA key). I tried this and when attempting to connect again, a prompt box appeared asking for a network key (also called a WEP or WPA key).I have also read that WEP needs to be switched to WPA. When I enter the router password, the following message appears: the network password needs to be 40bits or 104bits depending on your configuration. When I enter the router password, the following message appears: the network password needs to be 40bits or 104bits depending on your configuration.IP – 192.168.1.10Subnet – 255.255.255.0Default Gateway – 192.168.1.1 DNS – 22.214.171.124 I can connect to the wireless network using these settings, but I have no internet...Note: I updated the wireless adapter driver now untick "Enable IEEE 802.1x authentication for this network" and click Ok. If this fails to resolve your issue, remove your network from the Prefered Networks list and then just use the Wireless Network Setup Wizard found in Control Panel to create your wireless network.
It used to work so I know it\u0027s fundamentally ok.To configure additional wireless network connection settings, or if you are having difficulty making a connection to the wireless network that you selected, click Advanced, and then configure the settings in the Wireless Networks tab.All was fine except that I can still access 192.168.1.1, the configuration setup page of the router, within the local wireless after I disabled "Remote Management".I just installed a new Linksys ADSL modem/router at home.On installation, my sons (Vista) machine connected instantly and is running like the clappers. Sly Even if this was working before (on two machines simultaneously?